Loyal - Roth Manufacturing - Feed Handling Systems

GALVANIZED CONVEYORS
(SINGLE-CHAIN)
Features & Construction

DON'T BE FOOLED! Important Conveyor Chain Information

We've seen imported chain with a very-low tensile strength being
marketed. The tensile strength on 667H imported chain we had tested
was only 5,500# versus 9,500# on the domestic chain that we sell.

Avoid the "horror-stories" of premature chain-failure and accelerated, sprocket wear from imported, low-tensile chain. We offer domestic,
high-tensile chain... and at a lower price!

Heavier-gauge, rust-resistant galvanized-steel construction resists forage acids for longer life
Sturdy, detachable or pintle conveyor chain is tempered hard for longer wear
High-grade, corded-rubber 'plow contour' flights are reinforced with rugged steel brackets - flights are closer spaced for faster, higher-capacity feed delivery with minimum rideup
Conveyor-chain take-up (bolt type) located at discharge end. Fast and simple to adjust - up to 2" adjustment - few turns of two nuts are all that is required. Doesn't affect roller-chain drive adjustment
Enclosed, lower trough for clean, chain return and extra strength
Heavy cast-iron, drive and idler shaft, conveyor-chain sprockets – sprocket design helps prevent material buildup between chain and sprocket
Bronze, pillow-block bearings with grease fittings - resist forage acids for longer life. Two bearings, not just one, on each idler, drive and cross shaft to reduce wear on sprockets, shafts and bearings.
Heavy-gauge steel fixed boot - equipped with water drain holes to help prevent freeze-up in cold weather
Sliding motor mount may be set at any point along top elevator flange (underslung mounts also available)
Replacement pan or trough easily slips over existing pan or outside bottom trough, without having to replace sides of trough (pop rivet or tack weld to existing pan or trough)
Wider choice of accessories to custom-make a one-man feeding system. Available with transports, motors, declines, covers, special hoppers, hoods, downspouts and diverters