Begin with basic elevator... and custom make a bale handling system to fit your specific needs... all at a surprisingly low cost!
Basic elevator includes a drive unit, plus an end section with sprocket and chain tightener. Basic elevator can be easily lengthened by adding inter-changeable long and short center extensions.

Order motor and motor pulley separately.

• High-strength 1" square tubing - 70% more flexural strength than comparable round tubing

• Heavier design - use as inclined conveyor, mow conveyor or both

• Thick-walled 18 ga. steel construction

• Thicker-walled 15 ga. steel construction

• 'Bridge Truss' side reinforcements along full length of elevator prevent sagging, bowing, twisting, and bending. Inclined elevators are self supporting up to 54'

• Higher, side rails allow bales to sit down deep in elevator (preventing irregular shaped bales from tumbling out)

• Extra heavy-duty No.62 conveyor chain equipped with raised links every 24" for more positive movement

• Heavy-duty No. 55 conveyor chain equipped with raised links every 24" for more positive movement

• Bronze, pillow-block bearings on drive unit - self-aligning with grease zerks

• Full 1" solid head and jack shafts

• Permanently-lubricated, sealed ball-bearing idler sprockets

• Greaseable, bronze-bushing idler sprockets

• Stronger No. 40 roller-chain final drive

• All electrically wire-welded construction - welds go all the way around seams for added strength

• Sturdy, universal motor mount for electric motor is adjustable for leveling, belt take-up and "stop and go" operation. Mount is quickly detachable for inside storage of motor (drive belt included)

• Powder-coated bright-red finish... for longer life